Autoscaling#

SkyServe provides out-of-the-box autoscaling for your services.

Fixed Replicas#

In a service YAML, the number of replicas to launch is specified in the service section’s replicas field:

service:
  readiness_probe: /
  replicas: 2

# ...

In this case, SkyServe will launch 2 replicas of your service. However, this deployment is fixed and cannot adjust to dynamic traffic. SkyServe provides autoscaling to help you scale your service up and down based on traffic, as shown below.

Enabling Autoscaling#

Here is a minimal example to enable autoscaling for your service:

service:
  readiness_probe: /
  replica_policy:
    min_replicas: 2
    max_replicas: 10
    target_qps_per_replica: 2.5

# ...

In this example, SkyServe will:

  • Initially, launch 2 replicas of your service (min_replicas)

  • Scale up gradually if the traffic is high, up to 10 replicas (max_replicas)

  • Scale down gradually if the traffic is low, with a minimum of 2 replicas (min_replicas)

The replica count will always be in the range [min_replicas, max_replicas].

Autoscaling is performed based on the QPS (Queries Per Second) of your service. SkyServe will scale your service so that, ultimately, each replica receives approximately target_qps_per_replica queries per second. This value can be a float; for example:

  • If the QPS is higher than 2.5 per replica, SkyServe will launch more replicas (but no more than 10 replicas)

  • If the QPS is lower than 2.5 per replica, SkyServe will scale down the replicas (but no less than 2 replicas)

Specifically, the current target number of replicas is calculated as:

current_target_replicas = ceil(current_qps / target_qps_per_replica)
final_target_replicas = min(max_replicas, max(min_replicas, current_target_replicas))

Tip

replicas is a shortcut for replica_policy.min_replicas. These two fields cannot be specified at the same time.

Tip

target_qps_per_replica can be any positive floating point number. If processing one request takes two seconds in one replica, we can use target_qps_per_replica=0.5.

Scaling Delay#

SkyServe will not scale up or down immediately. Instead, SkyServe will only upscale or downscale your service if the QPS of your service is higher or lower than the target QPS for a period of time. This is to avoid scaling up and down too aggressively.

The default scaling delay is 300s for upscale and 1200s for downscale. You can change the scaling delay by specifying the upscale_delay_seconds and downscale_delay_seconds fields:

service:
  readiness_probe: /
  replica_policy:
    min_replicas: 2
    max_replicas: 10
    target_qps_per_replica: 3
    upscale_delay_seconds: 300
    downscale_delay_seconds: 1200

# ...

If you want more aggressive scaling, set those values to a lower number and vice versa.

Scale-to-Zero#

SkyServe supports scale-to-zero.

If your service might experience long periods of time with no traffic, consider using min_replicas: 0:

service:
  readiness_probe: /
  replica_policy:
    min_replicas: 0
    max_replicas: 3
    target_qps_per_replica: 6.3

# ...

The service will scale down all replicas when there is no traffic to the system and will save costs on idle replicas. When upscaling from zero, the upscale delay will be ignored in order to bring up the service faster.